![]() Track, then configure the connection for the "command station" type of "PR4 Standalone If you will only use JMRI to program decoders on the PR4 dedicated programming.Use when configuring JMRI? That depends on what you intend to do with JMRI. Throttle to select and control the locomotive on the dedicated programming track, subject In this mode, JMRI will be able to read and write decoder CV values forĭecoders on the PR4 dedicated programming track. Not be able to access the command station or LocoNet peripherals, and JMRI To the ability of the PR4 to supply sufficient current to the decoder. If you wish JMRI to be able to control decoders via the command station's programming.Throttles will not be able to control decoders via the "main track". Track and/or main track outputs, and access LocoNet devices, then configuring theĬonnection for the "command station" type suitable for your command station is appropriate. If you think that several modes may be useful to you, you should consider setting up.If you wish to use the PR4 to provide an interface to a LocoNet which does not have aĬommand station, then select "Standalone LocoNet" as the "command station" type.Not be able to run decoders which are on the command station's dedicated In this mode, JMRI is able to control decoders connected via the main track outputs andĪccess LocoNet devices and the command station's programming track. One configuration profile for each of the useful modes. Switch to the other mode, you may simply quit JMRI and re-start it, and select the another You may select the configuration profile which suits the way you want to use JMRI. ![]() Profile, so that you may perform some other type of work. When the PR4 is configured to act as a programmer, it is connected to a dedicated Programming track via the screw terminals on the PR4. When JMRI is properlyĬonfigured, JMRI can use the PR4 programming track to set CVs in any decoder that DecoderPro PS14, must be used with the PR4 in this case. This mode of operation can also be used to download sound information into Digitrax soundĭecoders and, within its limited current capability, run one locomotive to test it. ![]() With Digitrax SFX decoders, "neutral mode" allows you to vary the speed without the motor #Jmri decoderpro difference between internal and loconet download Moving the decoder, so you can hear how the locomotive sound reacts to varying speeds. #Jmri decoderpro difference between internal and loconet download.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |